 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| PCF is the classic traditional profile with classic back flange design. PCF Wedges are available in 52 degree gap wedge, 56 degree Sand Wedge and 60 degree Lob Wedge. The PCF also offers a wide sole platinum nickel in a 56 degree and a 60 degree. PCF wedges are investment cast for accuracy, but from a very soft stainless alloy (304) for a softer forged like feel. The sole design puts the primary bounce sole angle on each P-Series wedge from the toe across past the center of the sole - then the bounce sole angle is reduced under the heel so the golfer can roll the face open, rest the wedge on the heel for a finesse or higher shot, and not have the primary sole angle cause the sole to "bounce" and blade the shot at the slow head speeds of real finesse shots. Most other wedge series use ONE head design and offer many lofts. Yet the primary lofts preferred by players in a SW is 56 degrees, and 60 degrees for the Lob Wedge. Therefore, P-Series gives the option of different head designs, but created in the most popular lofts and created from soft steel that is easy to bend for loft or lie customizing. After casting, 304 Stainless has a natural hardness of Rockwell B83, which is actually lower than virtually all carbon steels. Finished in Bright Mirror nickel/chrome plating over soft 304 stainless steel. The PCF line is now available in a Platinum Nickel finish as well. (As shown above.) |
| Head Loft Lie Wgt Offset Sole Angle Toe Heel Sole Width T/H Hand WS 60* 64* 294 2.0 (10) (2) 59.0 3 24.0/20.0 RH WS 56* 64* 298 2.0 (14) (4) 60.0 38.0 25.0/21.0 RH PCF 52* 64* 284 2.0 (5) (0) 59.0 38.0 19.5/15.0 RH PCF 56* 64* 298 2.0 (11) (0) 62.0 40.0 21.0/16.0 RH PCF 60* 64* 294 2.0 (6) (0) 62.0 40.0 22.0/16.5 RH PCF 56* 64* 298 2.0 (11) (0) 62.0 40.0 21.0/16.0 B |
 | |  | |  | |  | |  | |  | |  | |  | |  |
